- Introducing the new WATERPROOF "EZON" LED Lighting system for Traxxas TRX-4 D110 Blazer Body from Club 5 Racing.
Designed from the ground up, specifically for scale crawler RC. User friendly is our #1 focus and simplicity is our ultimate goal. So you won't find any fancy flashing lights or confusing modes to set up, all functional lights are there to do what they're supposed to do. Installation can be done in 3 easy steps:
1. Attach all LEDs from primary circuit to TRX-4 body.
2. Reconnect steering servo / ESC / 3rd channel servo to secondary control circuit and receiver.
3. Connect primary and secondary circuit to complete.
One of the key design feature is that we have splitted the control unit into two circuits: Primary circuit on the body for all the LED connections and the Secondary control circuit with very small footprint remains on the chassis, small enough you can fit it in many of the stock water tight receiver box. So when you need to remove the body for replacing batter or if you need to do other maintenance, there is only ONE wire to disconnect from the chassis, that's how EASY it is!!
As for the TRX-4 body, all the wires are cut to length to fit the body perfectly! In additional We've also designed new front and rear light buckets / brackets to securely hold down all the LEDs attached, no more hot glue or shoe goo to mess around.
The Y connections to the Servo (CH1) and ESC (CH2) is also integrated into the secondary circuit to make the whole set up tidy. And there is an optional front /Rear Bumper lights will soon be available for your additional needs that can connect right into the secondary circuit.
Our Easy On control circuit will works on Traxxas TQi transmitter and most of other ones with two position third channel control such as Futaba or Speckrum. Besides turning signal lights, break lights and reverse lights will come on as controlled from the transmitter, you can have the total command over all the lights remotely through the third channel. However, with the limited remote channels available with the TQi system, we have programmed the control circuits differently for the TRX-4 command as followed for the Hi/Lo speed 3rd channel to control the "Easy On" system.
1. One click to turn on/off Fog Light*
2. Two clicks to turn on/off Head Light*
3. Three clicks to turn on/off Emergency Lights
*One click and two clicks on the third channel are interchangeable by switching the plugs (#5,#6) on the primarily circuit. With the default setting, you can have the head light always on ( two clicks) in either Hi or low speed and the fog light ( one click ) can serve as a speed indicator light when you're running at night.
LED Lighting system will include the following:
Primary Control Circuit ( for LEDs connections )
Seconday control Circuit ( for Signal connections )
Head light x 2 (Cold White 5mm)
Fog Light x 2 ( Warm White 3mm)
Turning signal lights x 4 (Yellow 3mm)
Braking lights x 2 (Red 5mm)
Reverse/Backing lights x 2 (Cold White 3mm)
Y connector x 1 ( for Channel 3 / Steering Servo)
Complete sets of 3D printed Front and Rear bucket / brackets
Zip tie and 3M Body wire clips
Don't forget to check out our demo video below......